• |
  • |
欢迎来到fun88乐天使备用工程有限公司官网!
全国咨询热线:1786660745615253122210
您的位置: 首页>> 产品中心 >>单层玻璃隔断

单层玻璃隔断尺寸

弹线:根据楼层设计标高水平线,顺墙高量至顶棚设计标高,沿墙弹玻璃隔断垂直标高线及天地龙骨的水平线,并在天地龙骨的水平线上划好龙骨的分档位置线。

在线咨询 服务热线17866607456      15253122210
产品详情

弹线:根据楼层设计标高水平线,顺墙高量至顶棚设计标高,沿墙弹玻璃隔断垂直标高线及天地龙骨的水平线,并在天地龙骨的水平线上划好龙骨的分档位置线。

Bullet Line: According to the high level line of floor design, design elevation from wall to ceiling, cut off vertical elevation line and horizontal line of skyscraper and skyscraper along wall bullet glass, and draw the grading position line of skyscraper on horizontal line of skyscraper and skyscraper.

条安装大龙骨:1.地骨安装:根据设计要求固定天地龙骨,如无设计要求时,可以用Ф8~Ф12膨胀螺栓或3~5寸钉子固定,膨胀螺栓固定点间距600~800mm。安装前作好防腐处理。2.沿墙边龙骨安装:根据设计要求固定边龙骨,边龙骨应启抹灰收口槽,如无设计要求时,可以用Ф8~Ф12膨胀螺栓或3~5寸钉子与预埋木砖固定,固定点间距800~1000mm。安装前作好防腐处理。

Installation of large keel: 1. Ground bone installation: Fixed skyscraper according to design requirements. If there is no design requirement, it can be fixed with expansion bolt 8-12 or 3-5 inch nail. The space between fixed points of expansion bolt is 600-800mm. Antiseptic treatment should be done before installation. 2. Installation of keel along the wall: According to the design requirement, the keel should be fixed, and the plastering receptacle should be opened. If there is no design requirement, expansion bolts of 8-12 or 3-5 inch nails can be used to fix the keel with embedded wooden bricks. The spacing between the fixed points is 800-1000mm. Antiseptic treatment should be done before installation.

主龙骨安装:根据设计要求按分档线位置固定主龙骨,用4寸的铁钉固定,龙骨每端固定应不少于三颗钉子。必须安装牢固。

Main keel installation: According to the design requirements, the main keel should be fixed according to the position of the grading line and fixed with 4 inch nails. Each end of the keel should be fixed with no less than three nails. It must be firmly installed.

小龙骨安装:根据设计要求按分档线位置固定小龙骨,用扣榫或钉子固定。必须安装牢。安装小龙骨前,也可以根据安装玻璃的规格在小龙骨上开安装玻璃槽。

Small keel installation: According to the design requirements, the small keel is fixed according to the position of the grading line, and fixed with a mortise or nail. It must be firmly installed. Before installing the keel, the glass groove can also be opened on the keel according to the specifications of the installation glass.

安装玻璃:根据设计要求按玻璃的规格安装在小龙骨上;如用压条安装时先固定玻璃一侧的压条,并用橡胶垫垫在玻璃下方,再用压条将玻璃固定;如用玻璃胶直接固定玻璃,应将玻璃先安装在小龙骨的预留槽内,然后用玻璃胶封闭固定。

Installation glass: Install the glass on the keel according to the specifications of the glass according to the design requirements; For example, fix the press strip on one side of the glass first, and use rubber pad under the glass, then fix the glass with the press strip; If fix the glass directly with glass glue, the glass should be installed in the reserved slot of the keel first, and then sealed and fixed with glass glue.

打玻璃胶:首先在玻璃上沿四周粘上纸胶带,根据设计要求将各种玻璃胶均匀地打在玻璃与小龙骨之间。待玻璃胶完全干后撕掉纸胶带。

Glass glue: Firstly, paper tape is glued around the glass. According to the design requirements, all kinds of glass glue are evenly struck between the glass and the keel. Tear off the paper tape when the glass glue is completely dry.

安装压条:根据设计要求将各种规格材质的压条,将压条用直钉或玻璃胶固定小龙骨上。如设计无要求,可以根据需要选用10×12mm木压条、10×10mm的铝压条或10×20mm不锈钢压条。

Installation bar: According to the design requirements, the bar of various specifications and materials will be fixed on the keel with straight nails or glass glue. If the design is not required, 10 *12 mm wood, 10 *10 mm aluminum or 10 *20 mm stainless steel can be selected according to the need./

热品推荐
XML 地图 | Sitemap 地图